Power & Utilities
FRP Grating for Power Plants & Utilities
Compare FRP panels for cooling-water access, utility platforms and equipment inspection routes, with resin and load selection tied to the operating conditions.
Power & Utilities
Application Requirements
Wet equipment areas, outdoor exposure and process chemicals create different requirements across a plant. Check temperature limits and fastening details. FRP grating does not replace an electrical safety, bonding or grounding design.
Typical Grating Locations
- Cooling tower fan decks and distribution basins
- FGD scrubber and absorber platforms
- Substation and switchyard walkways
- Cable trench and duct bank covers
- Battery room and inverter platform floors
- Boiler house and ash handling access
Typical grating locations for this environment. Confirm loads, supports and exposure for your site before ordering.
Products
Configurations to Consider
1 1/2" x 1 1/2" Square Mesh
SM 1-1/2"x1-1/2": 68% open area and 3.94 lbs/sf. Compare the published load data with your support layout.
Full specification →I-Bar PI-1560
PI-1560: 60% open area and 2.97 lbs/sf. Compare the published load data with your support layout.
Full specification →I-Bar PI-3060
PI-3060: 60% open area and 8.40 lbs/sf. Compare the published load data with your support layout.
Full specification →Installation Examples from the Catalog
These catalog photographs illustrate grating installations. They are not identified customer projects in this industry.
